Series 2000 Controller Setup Parameters; Sensor Default Settings - Ametek Thermox WDG Insitu User Manual

SENSOR DEFAULT SETTINGS

SERIES 2000 CONTROLLER SETUP PARAMETERS

O2 PRODUCTS
COMB. PRODUCTS
METHANE PRODUCTS
PARAMETER
SENSOR CONFIGURE O2
SENSOR CONFIGURE COMB
SENSOR CONFIGURE METHANE
SENSOR NODE ADDRESS
BAUD RATE
ENABLE SERIAL
COMBUSTIBLE TYPE
COMBUSTIBLE TYPE
COMBUSTIBLE SCALE
PROCESS PRESSURE
O2 SPAN GAS SETPOINT
O2 ZERO GAS SETPOINT
COMB SPAN GAS SETPOINT
METHANE GAS SETPOINT
AUTO CAL CYCLE TIME
AUTO CAL CYCLE FREQ
AUTO VERIFY CYCLE TIME
AUTO VERIFY CYCLE FREQ
AUTO CAL/VERIFY DAYS/HRS
AUTO CAL ENABLE/DISABLE
AUTO VER ENABLE/DISABLE
O2 PRODUCTS INCLUDE CLEAR AREAS ONLY
COMB. PRODUCTS INCLUDE CLEAR AND SHADED AREAS
METH. PRODUCTS INCLUDE CLEAR,SHADED,AND BORDERED AREAS
DEFAULT SETTINGS
CEM/O2, INSITU, WDG-IV, WDG-HPII
WDG-IVC, WDG HPIIC
WDG-IVCM
0
9600
ENABLED
HOTWIRE
RTD
PPM
0.00 PSIG
20.90%
2%
1600 PPM
2.00%
8:00
1 DAY
9:00
1 DAY
DAYS,DAYS
ENABLED
ENABLED
CUSTOMER SETTINGS
Sensor Default Settings | E-1