Set Cal Timers - Set Time And Date - Ametek Thermox WDG Insitu User Manual

With series 2000 control unit

Table of Contents

From the Set Cal Timers menu, select Set Auto Timers.

Select Auto Cal Cycle if defining an automatic calibration cycle. Select

Auto Verify Cycle if defining an automatic verification cycle.

Select Set Cycle in DAYS or Set Cycle in HOURS, depending on

whether you want to set the frequency of calibrations or verifications

in days or hours.

If you are setting the auto timers for the first time, the Series 2000



software will automatically prompt you to enter the current time and

date.

NOTE

You will be prompted to enter the frequency for the calibration or verifica-

tion cycle (either in days or hours, depending on what you selected:

Enter the number of days (or hours) for the automatic calibration or

verify cycle. As you enter the values, they overwrite the XXs on the

display. To enter 1 day or 1 hour, enter 01; otherwise, the system will

assume you are entering 10 days (or hours).

You will be prompted to enter the time of day when the first calibra-

tion of the cycle should begin:

Enter the time you want the first calibration or verification to begin,

then press Enter. The system uses military time, so to enter 4:00 p.m.,

you would type 16:00. If, for example, you set the cycle frequency at

8 hours, and specify the first calibration to take place at 4:00 p.m., the

next automatic calibration or verification will take place at midnight.

Set Cal Timers - Set Time and Date

Cal Cycle = 01 days

New Value = xx

Cal time is YY:YY

Enter new time Hr:Mn

Calibration | 5-15

Table of Contents