Start-Up Checklist - Ametek Thermox WDG Insitu User Manual

Start-Up Checklist

1-6 | Thermox Series 2000 WDG Insitu Analyzer
Review the Installation chapter (Chapter 3).

Install the sensor on the process

- If the sensor is on a pipe nipple, insulate the pipe from the process
wall to the mounting flange of the sensor.
Install the control unit.

- Do not create any additional conduit entries in the enclosure.
Interconnect the control unit and the sensor as shown in the intercon-

necting drawings.
- The specified cable must be used to ensure proper operation of the
system
- Keep the interconnecting located in the control unit as short as pos-
sible. You do not need to use a service loop.
- Maintain the ordered wire pairs as shown in the drawings.
Connect the AC mains supply to the control unit and the sensor. Make

sure that the AC voltage is within specified limits.
Configure your analyzer as explained in Chapter 4 - Controller/User

Interface.
Calibrate your system as described in the Chapter 5 - Calibration.
