Control Unit Mounting - Ametek Thermox WDG Insitu User Manual

Control Unit Mounting

The Series 2000 Control Unit comes with various mounting options.
•
The weatherproof enclosure can be mounted to either a panel, a wall, or to a
pole.
• The general purpose enclosure can be mounted as a panel, a rack, or a
wall mount.
Find the section below that corresponds to the type of control unit mounting con-
figuration you ordered, then mount as shown in that section.
Figure 3-9. series 2000, weatherproof panel mount.
Figure 3-10. series 2000, weatherproof wall/pole mount.
Weatherproof - Panel
Figure 3-9 shows the panel mounting dimen-
sions for the Series 2000 weatherproof enclo-
sure. Use 1/4" diameter fasteners to mount the
control unit to the panel.
Weatherproof - Wall/Pole
Figure 3-10 shows the wall and pole mounting
dimensions for the Series 2000 weatherproof
enclosure. For wall mount installations, use
1/4" diameter fasteners to mount the control
unit to a wall. For pole mount installations, the
two slots on the backplate of the enclosure
can be used to accommodate a customer-
supplied U-bolt of 3/8" or 1/2" diameter for a 2
1/2" to 4 1/2" pole diameter.
Installation and Start-Up | 3-9