AT&T 7400B Plus User Manual page 113

DEFINITY Communications System
7400B Plus Data Module
User´s Guide
Placing a Call
Disconnecting a Call
PC to PC Calls
At the Main menu select "I" to "Initiate a Session."
1
Select the ATTMAIL activity file.
2
Select the 7400B Plus connection file. (Smartcom III will
3
connect into the Direct Mode).
Select the ATTMAIL call setup macro which contains the
4
"atdt" command and phone number. (Smartcom III will dial out
to ATTMAIL).
Wait for a "CONNECT" message.
5
Once the call is established, press <ENTER > to get the
6
ATTMAIL login prompt.
Type in: +++ , wait for an "OK" from the 7400B Plus.
1
Type in: ath<ENTER> (The 7400B Plus will disconnect from
2
the other computer).
Select "F2" to return to the Main menu.
3
Select "T" to "Terminate the Session."
4
Select the proper session to terminate and press <ENTER>.
5
Initiate another call by selecting "I" or select "Q" to quit
6
Smartcom III and exit to DOS.
On PC to PC calls, the call originator and the call receiver should
refer to the sections for "Configuring the Software," "Building the
Call Set-up Macro," and "Placing a Call".
Neither party should select the maximum speed option.
To set a PC to answer calls automatically, the following command
sequence must be sent to the attached 7400B Plus:
ats0=1 x1 &w
Enter this command manually or via a keyboard macro key. This
command instructs the 7400B Plus to automatically answer calls
on the first ring, enable the extended numeric result codes
(indicates speed at which connection is made), and store this
configuration profile in non-volatile RAM location 0.
CHAPTER 4: PC APPLICATIONS
Page 4-61