AT&T 7400B Plus User Manual page 43

DEFINITY Communications System
7400B Plus Data Module
User´s Guide
Storing a Telephone
Number
The 7400B Plus is capable of storing up to four telephone
numbers, each of which can contain up to 25 characters. Numbers
stored in this way remain available indefinitely, even after the
7400B Plus has been powered off and then on again.
Table 3-4 describes the command lines used to store a telephone
number, delete a number from storage, and dial a stored number.
Note: Digits 0 through 9 and all letters ''a'' through ''z'' and
''A'' through ''Z'' may be part of the stored ''number.''
Spaces and hyphens (-) may be used in the number when
typing the command line. Spaces are not stored and do
not add to the total count of characters in the stored
number, but all other ASCII characters are stored and
counted. Any ASCII character may be used, as long as it
is acceptable to the PBX. A semi-colon (;) character
cannot be stored because it is used to delimit the end of
the string being stored so that additional commands can
be entered on the same command line.
CHAPTER 3: CONFIGURATION AND OPERATION
Page 3-11