AT&T 7400B Plus User Manual page 128

CHAPTER 5: TROUBLESHOOTING
Page 5-6
Symptom
Dialing begins before
the second dial tone is
heard.
The 7400B Plus does not
dial a voice call.
The 7400B Plus does not
pause when a comma is
inserted for a voice dial
call.
Problem
Incorrect dialing pause.
The voice terminal is
not connected to the
7400B Plus, an
unsupported voice
terminal is being used,
or the 7400B Plus is not
optioned for voice
dialing.
The comma delay is set
to 0 (zero).
DEFINITY Communications System
7400B Plus Data Module
Solution
Insert a comma in the telephone
number after the 9 (digit used
for calls outside the PBX).
atdp9,555-1212 (
If the problem persists, insert
another comma for a second
pause.
atdp9,,555-1212 (
and try again.
Check your PC communications
package to make sure it is a
valid character.
Check to make sure the voice
terminal is plugged into the
PHONE jack of the 7400B Plus.
Check the Features section of
Chapter 1, "Introduction" to
determine if the voice terminal
is supported.
Check that the line is
administered correctly and
optioned for voice dial (SW1-1).
Check your PC communications
package to make sure it is a
valid character.
Enter
ATS8=2 ( )
Enter
to set the pause to 2 seconds.
User´s Guide
)
Enter
)
Enter