AT&T 7400B Plus User Manual page 164

APPENDIX C: S-REGISTERS
Page C-8
Register:
Description:
Range of
Values:
Storable:
Comments:
See Also:
Register:
Register:
Description:
Range of
Values:
Storable:
Comments:
See Also:
Register:
S8
This S-register controls the duration of delay for pauses for voice
calls.
Value may be 000 through 255 seconds; factory-default is 2
seconds.
no
The 7400B Plus supports the comma dial modifier to provide
pauses in the dialing process for a voice call. (The comma is sent
to the switch for data calls).
Appendix B, "Dial Modifier."
S9 — not used
S10
The value in this S-register determines how long the 7400B Plus
will wait after loss of line signal is detected before disconnecting.
Value may be 000 through 255 tenths (0.1) of a second; factory-
default value is 014 tenths of a second (1.4 sec.).
no
The delay set by this S-register allows the receive line signal to
disappear momentarily without causing a disconnect (hang-up).
Setting this S-register to the maximum value (255) causes the
Data Module to ignore receive line signal status and not
disconnect the data call if line signal is lost.
Chapter 3, "Configuration and Operation."
S11 — not used
DEFINITY Communications System
7400B Plus Data Module
User´s Guide