AT&T 7400B Plus User Manual page 106

CHAPTER 4: PC APPLICATIONS
Page 4-54
Disconnecting a Call
PC to PC Calls
Press "F1" to return to the Main menu.
1
Select "0" (End Communication/Program) at the "Enter
2
Selection" prompt.
Select "H" to hang up (Smartcom II will hang up and reset the
3
7400B Plus).
To place another call, repeat the steps in the "Placing a Call"
4
section or select "O" and press "E" to exit Smartcom II and
return to DOS.
Call Originator
1
From the Main Menu, select 6 for Change Configurations.
a
From the Configurations screen, under Direct Connect
Port, select COM1.
At the parameter set to be used for the call, select
b
DIRECT <speed> as the Connection Type.
Select the Macro screen and edit the Automatic Log-on
c
Macro as shown below:
Name Of Macro: Z - Automatic Log-On
Time-out Prompt
-------- ------
0 0 (off)
1 0 (off)
1 0 (off)
Figure 46 Smartcom II - Initialization macro
From the Main Menu, select O to Originate a Call.
d
Call Receiver
2
Follow the same steps as outlined above for the Call
a
Originator, but on the last line of the Automatic Log-on
Macro, replace the atdt<phone#> entry with ats0=1.
DEFINITY Communications System
MACRO DEFINITION Press F2 For Help
Set: Q - ATTMAIL
Data
-----------------------------------
atz^^
at &c1 &d2 e1 v1
atdt9,1-800-624-5123
R(ecord, I(gnore, E(race: R
7400B Plus Data Module
User´s Guide
Send CR
-------
YES
YES
YES