Smartcom Ii - Prior To Version; Smartcom Ii; Smartcom Ii - V 3.1 (Macintosh) - AT&T 7400B Plus User Manual

DEFINITY Communications System
7400B Plus Data Module
User´s Guide
SMARTCOM II - PRIOR TO
VERSION 3.1
7400B Plus
Caveats
Configuring For Direct
Mode
SMARTCOM is a data communications software package
produced by Hayes Microcomputer Products, Inc.
The 7400B Plus is set up in Smartcom II's Direct Mode.
When originating calls, the type of connection must always
1
be set to DIRECT CONNECTION.
When setting the Remote Access feature, the connection type
2
selected should be either CCITT 1200 or CCITT 2400.
When selecting a file transfer protocol, xmodem should be
3
selected.
Change to the SMARTCOM II directory.
1
At the DOS prompt type in "scom" to load in Smartcom II.
2

Smartcom II

Hayes Microcomputer Products, Inc.
1. Begin Communication *. Receive File
2. Edit Set *. Send File
3. Select File Command 6. Change Configuration
A,C - Change Drive
Press F2 for Help
Enter Selection: 1 Press F1 To Return On-Line
Dials or answers phone with Smartmodem
Figure 36 Smartcom II - MAIN Menu
Select "6" for the "Change Configuration" menu at the Enter
3
Selection prompt.
CHAPTER 4: PC APPLICATIONS
Page 4-43
7. Change Printer Status (OFF)
*. Select Remote Access (OFF)
9. Display Disk Directory (OFF)
0. End Communication/Program