Configuring The Software - AT&T 7400B Plus User Manual

CHAPTER 4: PC APPLICATIONS
Page 4-50

Configuring the Software

Access the Smartcom II utility program SCOMMDM.EXE by
4
typing in: "SCOMMDM."
The following screen is displayed:
COMMANDS:
RESULT CODE:
These commands are sent to the modem when the program begins.
Save and Exit: F1
Figure 41 Smartcom II - SCOMMDM.EXE File
Set the commands for the Modem Configuration to match
5
those in the figure above.
Press F1 to save and exit.
6
To configure the software do the following:
To display the Main menu, type "scom" at the DOS prompt.
1
Smartcom II v3.1
1. Begin Communication *. Receive File
2. Edit Set
3. Select File Command 6. Change Configuration
A,B - Change Drive
Enter Selection: 1
Figure 42 Smartcom II - Main menu
DEFINITY Communications System
MODEM CONFIGURATION
Initialize 1: ATEO V1 QO X1 S0-0 & C1 & D2
Initialize 2:
Dial: ATDT
Auto Answer: ATS0=1
Hangup: ATHO
Escape Sequence: +++
Escape Guard Time: 1100 ( 0-5100 0.001 seconds )
Connection: CONNECT
Default Setting: F2
Hayes Microcomputer Products, Inc.
*. Send File
Press F2 for Help
Press F1 To Return On-Line
Dials or answers phone with Smartmodem
7400B Plus Data Module
User´s Guide
Quit: ESC
7. Change Printer Status (OFF)
*. Select Remote Access (OFF)
9. Display Disk Directory (OFF)
0. End Communication/Program