AT&T 7400B Plus User Manual page 60

CHAPTER 4: PC APPLICATIONS
Page 4-8
Placing a Call
* This option may not be available on earlier versions of CROSSTALK.
Select the Baud Rate that will be used most often and press
9
< ENTER> .*
Select the type of Video Display that you are using and press
10
< ENTER> .*
Enter "Y" to save the new default settings.
11
Press < ENTER> to display the Command files on the Status
12
Screen.
Example Setup: (For example purposes, a call to ATTMAIL will be
used for the setup.)
To create a command file to dial up a computer system that you want to
call for the first time, use the "NEWUSER" script file.
Load the Newuser file by either choosing the number next to
1
the command file "NEWUSER" on your Status screen or by
pressing < ENTER> to access the command line and type in:
"LO"ad "NEWUSER."
Press < ENTER> to continue.
2
Select a modem type from the list below (enter "Z" if modem is not listed).
A - AT&T (all models)
B - Bizcomp PC-Intellimodem (internal board)
C - Bytcom 212 AD
D - Concord Data Systems Autodial 224
E - Compaq (all models)
F - DCA modems (all models)
G - General DataComm 212 Intelligent Modem
H - Grid Case internal modem
I - Hayes Smartmodem (all models)
J - IBM PC modem or IBM 5841 modem
K - Lockheed GETEX modem
L - Multi-Tech (all models, 1200 and 2400 BPS)
M - Novation modem
N - Popcom C100 (internal) or Popcom X100 (external)
O - Racal-Vadic 3451 or Auto-dial VA212
P - Rixon PC-212a (internal) or Rixon Executive 212
Q - SmarTEAM modems (all models)
R - Telebit Trailblazer
S - U.S. Robotics (all models)
T - Ven-Tel Modem (all models)
U - Zoom Telephonics Modem (all models)
Z - Other modem not listed
Enter modem type (A-U, or Z):_
Figure 5 Crosstalk XVI - Services screen
DEFINITY Communications System
7400B Plus Data Module
User´s Guide