AT&T 7400B Plus User Manual page 100

CHAPTER 4: PC APPLICATIONS
Page 4-48
Disconnecting a Call
PC to PC Calls
To terminate the call, press "F5" and the appropriate letter for
1
the disconnect macro.
Press "F1" to return to the Main menu.
2
Select "0" (End Communication/Program) at the Enter Selection
3
prompt.
Select "H" to hang up, Smartcom II will reset automatically.
4
To place another call, repeat the steps in the "Placing a Call"
5
section or select "0" and press "E" to exit Smartcom II.
On PC to PC calls, the call originator and the call receiver should
refer to the sections for "Configuring the Direct Mode," "Setting
the Call Parameters," "Building a Macro," and "Placing a Call".
In addition to this, the call receiver should use the guidelines
below to set the PC to answer calls automatically.
Edit the Automatic Log-on macro by replacing the
1
atdt<phone#> entry with ats0=1.
At the Main Menu, select O to Originate a call.
2
DEFINITY Communications System
7400B Plus Data Module
User´s Guide