Advertisement
・ Press "STOP" button of VIBRATION switch of the VR
adjustment equipment to stop vibrations.
・ Rotate the lens through 90° in the direction indicated by the
arrow, then press "START" button of VIBRATION switch
to start vibrations.
・ At the 90° position, adjust the angle misalignment and
make gyro-gain adjustment.
Note: When adjusting the lens at the 90 ° position, adjust by
the buttons for the adjustment at 90 ° position as shown
below.
・After the adjustment, click the [Rewrite] button to write the adjustment value in EEPROM in the lens.
・Then, click the [EXIT] button to evacuate from the adjustment mode.
Notes：If clicking [EXIT] button after not clicking the [Rewrite] button, the adjustment value is not stored
and the adjustment is not influenced.
・Click the [Quit] button at the Adjustment Items window to go back to the Lens Selection window.
Notes：Do not remove the lens or turn OFF the VR lens adjustment equipment until it goes back to the
Lens Selection window. The trouble that the adjustment value is not stored correctly, etc. occurs since
the communication is cut off.
- Ａ 53・AF-S VR 70-300/4.5-5.6G -
INC
JAA79551-R.3690.A
Buttons for adjustment
at 90 ° position
Advertisement
