Advertisement
INC
JAA79551-R.3690.A
VR ADJUSTMENT
When performing the VR adjustment, please refer to the [Instruction Manual] attached to the VR lens adjustment
equipment (J15380).
WARNING
!
This equipment uses the laser beam.
●
Do not look into the laser beam directory.
Preparation for the VR adjustment
① Set up the VR lens adjustment equipment (J15380) as shown in Figure below.
② Connect the personal computer to the equipment and run the personal computer.
③ Mount the lens on the equipment. Set the focus ring to the infinity position and the zoom ring to TELE side.
Please refer to the next page for the procedure to mount the lens.
RS232C cable
Personal computer
Laser beam outgoing port
Laser beam
Power switch
「SERVO」switch
VR lens adjustment equipment
「VIBRATION」switch
（J15380）
Notes: The distance from the laser beam outgoing port to the radiation face should be about 5m apart.
Do not intercept the optical path of the laser beam.
- Ａ 42・AF-S VR 70-300/4.5-5.6G -
Advertisement
