Advertisement
⑮ The reconfirmation screen is displayed. Click "OK".
⑯ An hourglass is displayed on the screen, and writing starts.
The below screen is displayed after a few seconds. Turn camera OFF and turn it ON again.
Click "OK", and the adjustment software restarts.
Note: Unless the camera is turned off once, the value that was written in EEPROM is not reflected.
⑰ When the adjustment software restarts, perform the operations from ② to ⑫ again. Check that "0μm" of
the AF position is in focus.
(It is also possible, after Wide-side shooting of ⑪ , to take the Tele-side shooting of ② .)
If "0μm" is not in focus, repeat the operations from ② to ⑰ .
If it is not still in focus even after repetition, the written value in EEPROM may be abnormal. So click
"Design value Rewriting" to write the initial value, then proceed with the operations.
- Ａ 75・AF-S VR 70-300/4.5-5.6G -
INC
JAA79551-R.3690.A
Advertisement
