Voice Office Configuration Requirements Voice Office Application Prerequisites; Implementation Workflow - Nortel 1000 Configuration Manual

Voice Office Application Prerequisites

Implementation Workflow

Before configuring the Voice Office applications, complete the following
tasks:
Refer to the Nortel support site for the latest firmware releases.
•
Complete the Application Gateway Pre-Installation Checklist.
•
Install and complete the initial configuration of the Application
•
Gateway as described in the Application Gateway Quick Start Guide.
If a Network Address Translation (NAT) device is between the
Note
Application Gateway and the phones, you must enter the NAT IP
address on the Network > Interfaces page. The Application
Gateway advertises the NAT IP address in messages relating to
setting up audio streams, as required by UNISTIM. NAT is
supported for Express Directory and transformed applications.
If you have license files that have not been uploaded to the
•
Application Gateway, use the Application Gateway Administration
Tool to upload the license files, as described in the Application Gateway
Administration Guide.
Licenses that you purchase with the Application Gateway are
pre-installed. You must upload subsequently purchased licenses. For
background information on licensing, as well as instructions for
managing licenses, refer to the Application Gateway Administration
Guide.
The following general steps provide a suggested workflow for
implementing Voice Office applications.
Determine which Voice Office applications are to be deployed and to
1.
which phones.
Customize the Voice Office Menu accordingly, as described in
2.
"Customizing the Voice Office Menu," page
Chapter 1 Voice Office Configuration Requirements
Voice Office Application Prerequisites
Voice Office Application Suite Configuration Guide
5.
3