Preparation For Communication - Epson SRC520 Manual

9.2 Preparation for Communication

For communication via RS-232C between the Control Unit and peripheral equipment to
work, the port configuration on both units must be the same. Make sure that the settings
on the following parameters on both units match.
command or go to [Setting of a Robot Controller] - [COM Port] to set up the following
parameters:
- Port #
- Baud Rate
- Data Bit Length
- Stop Bit
- Parity
- Terminator
- H/W Flow Control
- S/W Flow Control
- Timeout [sec.]
For details on the set-up procedure and communication commands, refer to the
SRC5**/SPEL 95 User's Guide for "7. Communication with External Equipment".
Function 9.2 Preparation for Communication (RS-232C Settings)
You may use either SETCOM
83