Epson SRC520 Manual page 8

Differences between SRC520 and SRC520CE
This manual describes about the robot controller SRC520 (including SRC520CE).
The controller consists of one Control Unit and Drive Unit(s). You may find the
controller model name on the front panels of them.
The model, SRC520 and SRC520CE, are quite different. Only SRC520CE is in
520CE
conformity with the following EC directives:
Conformed to:
Machinery directive
EMC directive
Low Voltage directive
SRC520CE Drive Unit(s) and SRC520CE Control Unit (with SPEL 95) compose
a SRC520CE.
SRC520CE will not meet the above-mentioned Standards when the SRC520CE is
remodeled and/or when the SRC520CE is connected with other controller.
SRC520CE provides only PNP-type I/O.
SRC520 provides NPN-type I/O, but PNP-type is prepared as an option.
SERVICE CENTER
Contact the following service center for robot repairs, inspections or adjustments.
Please have the model name, the Serial No. of each unit, software version and
a description of the problem ready when you call.
MANUFACTURER
SEIKO EPSON CORPORATION
Okaya Plant No. 2
1-16-15, Daiei-cho, Okaya-shi, Nagano-ken, 394-0025, Japan
TEL: 81-266-23-0020 (switchboard)
FAX: 81-266-24-2017
vi
81-266-24-2004 (direct)
Applied Standards
EN775, EN60204-1
EN55011, EN50082-2
EN60950