APRILIA RSV4 1100 Factory Service Station Manual page 96

Electrical system
•
Check the ground fastening on the starter motor, starter motor positive and relative hood.
•
Check the taillight connection.
•
Check the connection between the number plate holder wiring harness and the main wiring
harness.
•
Check the fuel pump connection.
•
Check the regulator connection.
•
Check fastening of the chassis - engine ground cable.
•
Check the Flywheel-Regulator connection.
•
Check the Lambda connection (Front Rear).
•
Check that the Lambda probe cable is routed correctly (Front Rear).
•
Check that the "ABS" connector is inserted correctly (Front Rear).
•
Check that the "ABS" sensors are correctly connected (Front and Rear).
•
Check that the RH and LH fan connector is connected correctly.
•
Check the injection relay connection (with diode).
•
Check that the cables on the starter relay are connected correctly and the torque cable
fastening screws are tightened correctly.
•
Check the rear stop switch connection.
•
Check that the R&W connector is connected and routed correctly.
•
Check the RH and LH rear indicator connections.
•
Check the gear connector connection.
•
Check the quick shift connector connection.
•
Check that all the connectors inside the instrument support arch have been connected cor-
rectly.
CAUTION
THE CONNECTORS INDICATED IN THE LIST ARE CIRCLED IN GREEN IN THE VARIOUS PHO-
TOS THESE CONNECTORS HAVE BEEN LISTED AS THEY ARE MORE CRITICAL THAN OTH-
ERS, AND THEIR DISCONNECTION MAY CAUSE VEHICLE BREAKDOWN OR MALFUNCTION.
NATURALLY, IT IS ALSO NECESSARY THAT ALL OTHER CONNECTORS CONNECTED COR-
RECTLY TO ENSURE THAT THE VEHICLE FUNCTIONS CORRECTLY. THE INSTRUCTIONS FOR
ROUTING AND FASTENING THE WIRING HARNESS THROUGHOUT THE VEHICLE MUST BE
FOLLOWED PRECISELY TO ENSURE THAT THE VEHICLE FUNCTIONS CORRECTLY AND RE-
LIABLY.
ELE SYS - 96
RSV4 1100 Factory