APRILIA RSV4 1100 Factory Service Station Manual page 363

RSV4 1100 Factory
•
Blue
•
Yellow
•
Green
For the coupling of the connecting rod with the crankshaft, according to the engraving on the counter-
weights, observe the following table:
Bushing colours
BLUE
YELLOW
GREEN
Selection connecting
rod pin dimension
X (35.885 - 35.880 mm)
Y (35.880 - 35.874 mm)
Z (35.874 - 35.869 mm)
Key:
(1) If using bushing of different thickness, install the thickest on the side of the connecting rod
shank
BIG END BUSHING REPLACEMENT PROCEDURE
When replacing the big end bushings, make sure that the tang of the semi-bushing is correctly housed
in the corresponding notch in the connecting rod stem or cap.
B
USHINGS THICKNESS
C
ONNECTING RODS COUPLING
Big end class 1 Big end class 2
Blue + Yellow (1) Yellow + Yellow
Yellow + Yellow Yellow + Green (1)
Yellow + Green (1) Green + Green
Thickness
1.547 - 1.552 mm
1.552 - 1.557 mm
1.557 - 1.562 mm
- C
RANKSHAFT
Required clearances
class 1
0.053 - 0.026 mm
0.054 - 0.026 mm
0.054 - 0.027 mm
Engine
Required clearances
class 2
0.053 - 0.027 mm
0.054 - 0.027 mm
0.054 - 0.028 mm
ENG - 363