APRILIA RSV4 1100 Factory Service Station Manual page 209

RSV4 1100 Factory
•
on the vehicle: The motor is located in
the front lower part of the engine. The
valve in the exhaust pipe.
•
connector: on the motor.
Electrical specifications:
•
Electric motor resistance (PIN 4-5): 2-4
Ohm
•
Potentiometer resistance (PIN 1-3):
10.1 kOhm +/- 10%
Pin out:
1. 5V supply voltage
2. Output signal (0- 5 V)
3. Ground
4. A motor power supply
5. B motor power supply
DIAGNOSTIC TOOL: PARAMETERS
Exhaust valve objective position: 0 - 100 %
NOTES: Value that the control unit sends to the
instrument panel to operate the valve: 0% (valve
closed), 100 % (valve open).
CAUTION
BEFORE CARRYING OUT ANY TROUBLESHOOTING,
CAREFULLY READ THE GENERAL TROUBLESHOOTING
CONCEPTS FOR ELECTRICAL DEVICES AT THE BEGIN-
NING OF THE CHECK AND CONTROL SECTION IN THE
ELECTRICAL SYSTEM CHAPTER.
DIAGNOSTIC TOOL: STATUSES
Exhaust valve
•
Not determined/searching/activation at key ON/ in operation/ stopped due to detected faults/
zero searching.
NOTES: If there is no problem, the following is displayed: in operation.
DIAGNOSTIC TOOL: ELECTRICAL ERRORS
P1501 Exhaust valve stoppers search
Diagnosis:
•
potentiometer signal above the maximum threshold/ potentiometer signal under the mini-
mum threshold/excessive duration/search not performed.
Error cause:
Electrical system
ELE SYS - 209