APRILIA RSV4 1100 Factory Service Station Manual page 215

RSV4 1100 Factory
•
Bring the two adjuster screws of the
cables to zero, fully tightening them.
CAUTION
BRING BOTH NUTS OF THE TWO ADJUSTMENT SCREWS
UP AGAINST THE SUPPORT PLATE, WELDED TO THE SI-
LENCER;
•
Connect the PADS and carry out the "valve zero" (actuator in the corresponding valve fully
open position);
CAUTION
CHECK THAT THE PULLEY HAS THE END-STOP RESTING AGAINST THE END-STOP OF THE
SILENCER
Electrical system
ELE SYS - 215