APRILIA RSV4 1100 Factory Service Station Manual page 144

Electrical system
•
Filled
Error cause
•
This indication appears only if the Level 2 safety has reset the engine (C gravity).
The instrument panel does not indicate the presence of this error even in the ATT status
Troubleshooting
•
Perform the troubleshooting for the other detected errors.
P1608 a-PRC (Aprilia Performance Ride Control) functional error
Electrical diagnosis:
•
Incorrect a-PRC scheduling / Incorrect CheckSum of the software on Flash / Control unit
voltage too low for a-PRC controls
Error cause
•
Due to the fact that the safety system detected a serious fault, the control unit has disabled
the a-PRC system.
The instrument panel indicates this error by lighting up in a fixed manner the MI warning light.
Troubleshooting
•
Contact technical service.
NOTE
THIS ERROR DISABLES THE TRACTION CONTROL.
P1650 Engine events configuration Checksum calculation error
Error cause:
•
Corrupt Flash-eeprom (hardware problem).
•
Upload (e.g. in service) of an incompatible software version, therefore missing the reference
check-sum.
This error is indicated by lighting up in a fixed manner the general warning light.
Troubleshooting:
•
Call the Help Desk.
DIAGNOSTIC TOOL: ADJUSTMENTS
•
Vehicle config. (km) / - (vehicle configuration (km)
•
Vehicle config. (miles) / - (vehicle configuration (miles)
•
Handle self-learn. / - (handle self-learning)
•
Throttle valve self-learn. / - (Throttle valve self-learning)
•
EEPROM reset / - (control unit EEPROM memory reset)
•
Exhaust valve zero / - (Exhaust valve zero search)
•
Exhaust valve self-learn / - (exhaust valve self-learning)
•
Equiv. km reset. / - (equivalent km partial counter reset)
•
Key err count reset / - (ignition switch assembly errors counter reset)
ELE SYS - 144
RSV4 1100 Factory