APRILIA RSV4 1100 Factory Service Station Manual page 313

RSV4 1100 Factory
•
Install the intake and exhaust cam-
shafts on the front head, bearing in
mind that:
the exhaust camshaft gear tooth (indicated with a
dot) is meshed with the trough of the intake cam-
shaft gear (indicated with two dots).
CLEAN THOROUGHLY THE SEATS OF THE GEAR RE-
TAINER SCREWS, ON THE INTAKE CAMSHAFT.
•
Fit the U bolts with nine O rings and lo-
cator pins.
•
Position the screws (4), taking care to
insert new washers on the screws near
the spark plug holes.
•
Loosen the distribution gear's lock
screw and move the gear itself from the
mounting tool to the camshaft.
•
Unscrew and remove the two screws
(1).
•
Remove the tool.
•
Position the U bolt (2) and the oil pipe
(3).
•
Insert the two screws (1).
•
Tighten all the U bolts' screws working
in stages and diagonally.
Engine
ENG - 313