APRILIA RSV4 1100 Factory Service Station Manual page 369

RSV4 1100 Factory
ling on the connecting rod head must
face outward of its crank pin.
Specific tooling
020856Y Piston assembly ring
•
Remember to couple the connecting
rod shank and cap correctly, combin-
ing the respective numerical referen-
ces.
•
Use new connecting rod screws, lubri-
cating the thread and under the head..
•
Proceed with tightening according to
the procedure described in the tighten-
ing torque table using the torque
wrench and angular tightening with a
goniometer.
Crankcase closing
•
Insert the crankshaft together with con-
necting rods and pistons in the upper
crankcase.
•
Position the three centring dowels in
the crankcase.
•
Insert a new oil seal O ring in the spe-
cific seat.
Engine
ENG - 369