APRILIA RSV4 1100 Factory Service Station Manual page 482

Braking system
•
Fit the two new pads in the correct po-
sition.
ALWAYS REPLACE THE FOUR PADS AND MAKE SURE
THEY ARE CORRECTLY POSITIONED INSIDE THE CAL-
LIPER.
•
Fit the front brake calliper on the disc.
•
Hand-tighten the two screws (1) fully.
•
Pull the front brake lever to seat the
brake calliper correctly.
•
Tighten the two screws (1).
•
Check the front brake fluid level.
Rear brake pads
Removal
•
Rest the vehicle on its stand.
•
Remove the two fixing screws (1) and
free the brake calliper.
CAUTION
DO NOT OPERATE THE REAR BRAKE LEVER AFTER
HAVING REMOVER THE WHEEL, OTHERWISE THE PIS-
TON OF THE CALLIPER COULD EXIT THE SEAT, CAUSING
THE LOSS OF THE BRAKE FLUID.
•
Remove the stop ring (2).
BEFORE DISCONNECTING THE PIN (3), CHECK THE PO-
SITION OF THE SAFETY SPRING (4); IT MUST BE POSI-
TIONED IN THE SAME WAY ON REASSEMBLY.
BRAK SYS - 482
RSV4 1100 Factory