APRILIA RSV4 1100 Factory Service Station Manual page 241

RSV4 1100 Factory
•
Insert the rubber gasket housing the
USB port (4) into the support bracket
(3).
•
Then insert the USB port (5) in the rub-
ber gasket (4).
•
Operating from the left vehicle side, in-
sert the nut in the corresponding hous-
ing on the headlamp.
•
Place the wiring harness of the USB
cable (6) on the vehicle, making it pass
through the headlamp and the instru-
mentation support and recover the
connector (7) so as it is inside the in-
strumentation support compartment.
•
Connect the vehicle wiring harness
connector (7) to the USB wiring har-
ness connector (8) and place it care-
fully inside the instrumentation support
compartment
•
Fix the USB supporting clamp (3) to the headlamp with the screw (9) provided with the
washer (10)
Locking torques (N*m)
USB port support bracket fixing 6 Nm (4.43 lb ft)
Electrical system
ELE SYS - 241