APRILIA RSV4 1100 Factory Service Station Manual page 428

Chassis
•
Check the sprocket (7) toothing for proper conditions.
If there is excessive wear:
•
Replace the sprocket.
TO PREVENT NEW COMPONENTS FROM WEARING PREMATURELY, THE REAR SPROCKET,
FRONT SPROCKET AND DRIVE CHAIN MUST ALWAYS BE REPLACED TOGETHER AS A SET.
REAR WHEEL BEARINGS
•
Remove the rear wheel.
•
Clean both sides of the hub with a
cloth.
On the right hand side of the wheel:
•
Remove the right hand spacer (9).
•
Remove the seal (10).
•
Remove the circlip (11)
CAUTION
THE CIRCLIP (11) IS ONLY INSTALLED ON THE RIGHT
HAND SIDE OF THE WHEEL.
There are notches (A) for engaging with the teeth of the extractor tool at the ends of the spacer (12).
•
Use the extractor tool to remove the right hand bearing (13).
Specific tooling
AP8140180 Bearing extractor
•
Retrieve the inner spacer (12).
On the left hand side of the wheel:
•
Use the extractor tool to remove the left
hand bearing (16).
Specific tooling
AP8140180 Bearing extractor
•
Clean the interior of the hub thoroughly.
CAUTION
WASH ALL COMPONENTS WITH CLEAN DETERGENT SOLUTION.
CHAS - 428
RSV4 1100 Factory