Tasks For Installing And Configuring A Dialogic; Gateway; Bordernet™ 500 - Dialogic BorderNet 500 Installation And Configuration Manual

WAN Configuration
Using this configuration, the BorderNet 500 Gateway is connected to an outside network on one network interface
and your firewall on another network interface. Only data will be sent between these two interfaces. Other
network interfaces can be connected directly to your LAN, DMZ, or other networks. SIP traffic will be sent through
these other interfaces.

Tasks for Installing and Configuring a Dialogic

The following table describes the required tasks for installing and configuring a BorderNet 500 Gateway:
Task Description
1 Install the BorderNet 500 Gateway software.
2 Activate the BorderNet 500 Gateway licenses.
3 Understand the overall BorderNet 500 Gateway
configuration process.
4 Access the SIParator web interface.
5 Set up access to the configuration, including
setting up the network interfaces and setting up
access control.
6 Specify the Siparator type.
7 Configure basic SIParator services.
8 Configure SIP sessions and media services.
9 Configure SIP Interoperability.
10 Configure SIParator routing, including creating a
dial plan.
11 Apply the SIParator configuration.
Tasks for Installing and Configuring a Dialogic
®
For More Information, see
Installing the Dialogic
page 14.
Activating Licenses
Overview of Configuring the Dialogic
on page 22.
Accessing the SIParator Software Web Interface Directly from a
Browser on page 22.
Setting Up Access to the Dialogic
Configuration
Specifying the SIParator Type
Configuring Basic SIP Services
Configuring SIP Sessions and Media Services
Configuring SIP Interoperability
Configuring SIParator Routing
Applying the SIParator Configuration
®
BorderNet™ 500 Gateway
BorderNet™ 500 Gateway
®
BorderNet™ 500 Gateway Software
on page 19.
®
BorderNet™ 500 Gateway
®
BorderNet™ 500 Gateway
on page 24.
on page 26.
on page 27.
on page 29.
on page 30.
on page 35.
on
on page 28.
Page 13