Table of Contents
Advertisement
®
™
Dialogic
BorderNet
500 Gateways Installation and Configuration Guide
• If you answer n, nothing is removed.
• If you answer y, you have three update modes to select from:
1
Clear as little as possible. This is the alternative that is used if you answer n to the question above.
Both the preliminary configuration and the permanent configuration will be updated with the
configuration specified above.
2
Revert to the factory configuration and apply the configuration specified above. This will affect the
permanent configuration, but not the preliminary configuration.
3
Revert to the factory configuration, empty all logs, and apply the configuration specified above. Both
the preliminary configuration and the permanent configuration will be affected.
Update mode (1-3) [1]:
9. Select one of the three update modes described above.
The configuration is now complete. The installation program shows the configuration and asks if it is correct.
• yes saves the configuration.
• no runs the installation program over again.
• abort ends the installation program without saving.
You have now entered the following configuration
Network configuration inside:
Physical device name: eth0
IP address: 192.168.150.2
Netmask: 255.255.255.0
Deactivate other interfaces: no
Computer allowed to configure from: IP address: 192.168.128.3
Password: eeyore
The rest of the configuration is kept.
Is this configuration correct (yes/no/abort)? yes
10. Finish configuration of the BorderNet 500 Gateway from the computer/computers specified in the installation
program.
Turning Off a Dialogic
To turn off a BorderNet 500 Gateway, turn the computer off. The computer that runs the software is specially
designed so that you can switch it off without causing any problems in the file structure.
Locking Up a Dialogic
The BorderNet 500 Gateway must be protected from unauthorized physical access just as other computers
performing critical tasks. A locked up BorderNet 500 Gateway protects against:
• Connecting to the console
• Changing the administrator password using a reboot and the BorderNet 500 Gateway buttons.
For more information about the necessary configuration, see
BorderNet™ 500 Gateway
Page 18
®
TM
BorderNet
500 Gateway
®
TM
BorderNet
500 Gateway
on page 13.
Tasks for Installing and Configuring a Dialogic
®
Advertisement
Table of Contents
