3. In the Network Interfaces section, set the listen ports to 9803. All SIP traffic from the SIParator to Diva
SIPcontrol will come in through this port. For example:
4. Configure at least one SIP peer, as described in
5. Configure at least one SIP --> PSTN route and one PSTN --> SIP route, as described in
on page 38.
6. Click Save to save the settings.
Configuring SIP Peers
A SIP peer is a specific endpoint to and from which Diva SIPcontrol will establish calls. You can use peer-specific
settings to adapt Diva SIPcontrol's behavior towards this peer.
To configure a SIP peer, follow these steps:
1. From the main Diva SIPcontrol web interface page, click SIP Peers:
The SIP Peers options appear:
2. Do either of the following:
• To change a SIP peer's definition, click Details on the right side of the SIP peer's row, make the appropriate
changes to the options, and then click OK.
• To add a new SIP peer, click Add, make appropriate changes to the options, and click OK.
For more information about options for defining SIP peers, see the Dialogic
Reference Guide.
Configuring Dialogic® Diva® SIPcontrol™ Network Interfaces
Configuring SIP Peers
on page 37.
Configuring Routes
®
BorderNet™ 500 Gateways
Page 37