Table of Contents
Advertisement
®
™
Dialogic
BorderNet
500 Gateways Installation and Configuration Guide
4. In the Configuration Allowed Via Interface section, verify that the Eth0 field is set to On.
5. In the Configuration Computers section, enter the following settings:
• In the DNS Name or Network Address field, enter the DNS name or IP address for the physical network.
• In the Netmask/Bits field, enter 255.255.255.255 to allow configuration from just one computer, or a
broader netmask to allow configuration from multiple computers.
• Make sure the HTTP field is checked, if you plan to use HTTP via the browser.
For example:
6. Click Save to save the settings. These settings must also be applied on the Save/Load Configuration page
before they affect SIParator functionality. For information, see
page 35.
Specifying the SIParator Type
The SIParator can be connected to your network using one of the following configurations:
• DMZ, as described in
• DMZ/LAN, as described in
• Standalone, as described in
• WAN Configuration, as described in
Page 26
DMZ Configuration
on page 10.
DMZ/LAN Configuration
Standalone Configuration
WAN Configuration
Applying the SIParator Configuration
on page 11.
on page 12.
on page 13.
on
Advertisement
Table of Contents
