Table of Contents
Advertisement
®
™
Dialogic
BorderNet
500 Gateways Installation and Configuration Guide
®
Available Dialogic
BorderNet™ Gateway Versions
The following BorderNet 500 Gateway versions are available:
Version
Boards installed
BN500IP
None
IP only version with 25 SIP-to-SIP sessions
BN508BRI 1 x Dialogic
BN501PRI 1 x Dialogic® Blue™ OneSpan-24/30-S-LP
Telephony Board
BN504PRI 1 x Dialogic
Board
Note: For more information about licenses, see
Software Components
The following software is pre-installed on the BorderNet 500 Gateways:
®
®
• Dialogic
Diva
System Release LIN software, which includes the necessary Dialogic
installation, configuration, tracing, and line testing utilities
®
®
• Dialogic
Diva
SIPcontrol
including a web-based gateway configuration
• SIParator software
Configuration Types
The BorderNet 500 Gateway can be connected to your IP network in four different ways, depending on your needs.
DMZ Configuration
With the DMZ configuration, the BorderNet 500 Gateway is located on the DMZ of your firewall and connected
to it with only one network interface. The SIP traffic finds its way to the BorderNet 500 Gateway by either using
DNS or setting the BorderNet 500 Gateway as an outbound proxy on the clients.
This is considered the most secure configuration, since all traffic goes through both your firewall and your
BorderNet 500 Gateway. It is also considered the most flexible configuration, since all networks connected to
any of your firewall's network interfaces can be SIP-enabled.
Page 10
®
®
Diva
4BRI-8 PCI Media Board 8
®
®
Diva
V-4PRI PCIe HS Media
TM
Software, which includes the necessary SIP to PSTN gateway module installation
Channels
Channels T.38/Fax
PSTN
--
--
8
30
0
120
0 - 120 (separate license
needed; see note below)
Activating Licenses
on page 19.
SIP traversal channels
25
8
30
120
®
®
Diva
Media Board
Advertisement
Table of Contents
