Assigning Siparator Route Priorities - Dialogic BorderNet 500 Installation And Configuration Manual

® ™
Dialogic BorderNet 500 Gateways Installation and Configuration Guide
In the SIP --> PSTN running example, the From header matched the Buff_from_GS44 rule, and the Request-URI
matched the Buff_to_SIPc rule. This results in the call being forwarded to the entry in the Forward To table
labeled SIPc. In this case, SIPc points to the Diva SIPcontrol software component, which has the same IP address
as the SIParator, but a different port: 9803. Diva SIPcontrol will now take over and route the call based on its
routing rules.
In the PSTN --> SIP example, the From header matched the Buff_from_SIPc rule, and the Request-URI matched
the Buff_fSIPc_tL45 rule. This results in the call being forwarded to the entry in the Forward To table labeled
Grandstream44, which directs the call to an IP phone.
7. Click Save to save the settings. These settings must also be applied on the Save/Load Configuration page
before they affect SIParator functionality. For information, see
page 35.

Assigning SIParator Route Priorities

To assign route priorities to the SIParator, follow these steps after you create a dial plan;
1. Click SIP Traffic on the main menu of the SIParator web interface.
The SIP Traffic page appears.
2. Click Routing on the SIP Traffic page:
3. In the SIP Routing Order section, assign the highest priority (1) to Dial Plan.
4. In the Local REFER Handling section, verify that the Always handle REFER locally option is checked.For
example:
5. Click Save to save the setting. This setting must also be applied on the Save/Load Configuration page before
it affects SIParator functionality. For information, see
Page 34
Applying the SIParator Configuration
Applying the SIParator Configuration
on
on page 35.