Dialogic® Vision™ CX Video Gateway Administration Manual
Additional configuration tasks
The following table lists additional configuration tasks you may need to perform after
using the Vision™ Console, depending on the configured environment:
Models
Configuration task
All
Add additional settings for trunks in the board-0.cfg, board-1.cfg,
or board-2.cfg files.
Add additional settings for trunks and routes in the telecom.conf
file.
Note: You can also specify telecom.conf settings in the Options
page on the Configuration menu.
ISUP
Add additional settings for SS7 signaling trunk in
audio
/opt/nmstx/etc/cx/txcfg1.txt.
and ISUP
Add TX IP information required for SIGTRAN in
video
opt/nmstx/etc/cx/ipcfg1.txt.
models
Add MTP3, SIGTRAN, and ISUP configuration information in
opt/hs-data/raid/nms_hearsay/cfg/oam/ss7_config_default.xml.
Dialogic
Configuring the CX Video Gateway
For more
information, see...
Fine tuning the
media board
configuration on
page 112.
Fine tuning the
telecom
configuration on
page 116.
Dialogic® Vision™
Signaling Server
Administration
Manual.
35
Need help?
Do you have a question about the Vision CX Video and is the answer not in the manual?