Table of Contents
Advertisement
Applying the SIParator Configuration
When you are done with the preliminary configuration for the SIParator, you can test it as follows:
1. Click Administration on the main menu of the SIParator web interface.
The Administration page appears.
2. Click Save/Load Configuration on the Administration page:
3. Select Apply configuration.
The preliminary configuration now controls the SIParator functions.
4. Do either of the following:
• If the configuration works satisfactorily, click Save configuration to make it the permanent
configuration.The new configuration now controls the SIParator functions.
• If you are not satisfied with the preliminary configuration after testing, select Revert and then Abort all
edits. This discards all changes made in the preliminary configuration since the last time you applied a
configuration by clicking Save configuration.
Configuring Dialogic® Diva® SIPcontrol™ System Settings
To configure Diva SIPcontrol system settings, follow these steps:
1. Access the Diva SIPcontrol web interface, as described in
Interface Directly from a Browser
2. Click System configuration on the left side of the main Diva SIPcontrol web interface page:
The System Settings page appears.
Accessing the Dialogic® Diva® SIPcontrol™ Web
on page 23.
Applying the SIParator Configuration
Page 35
Advertisement
Table of Contents
