Agilent Technologies InfinityLab LC Series User Manual page 154

4 Preparing the Module
Setting up the Vialsampler
Setting up the Vialsampler
The setup of the Vialsampler is shown with the Agilent OpenLab ChemStation
C.01.07. Depending on the controller (e.g. Agilent Local Controller, OpenLab
EZChrom, Masshunter) the screens look different.
This section describes the Vialsampler settings only. For information on the
NOTE
software or other modules refer to the corresponding documentation.
Figure 29
After successful load of the OpenLab ChemStation, you should see the module
as an active item in the graphical user interface (GUI).
Agilent InfinityLab LC Series Vialsamplers User Manual
ChemStation Method and Run Control
154