Chrysler Dodge Caravan 2002 Manual page 1765

21 - 208 41TE AUTOMATIC TRANSAXLE
41TE AUTOMATIC TRANSAXLE (Continued)
(c) Remove oil pump o-ring (Fig. 144). Be sure
to reinstall oil pump o-ring after selecting the
proper #4 thrust plate.
(d) Set up input shaft for measurement with
Indicator Set C3339 and End Play Set 8266 as
shown in (Fig. 145).
(e) Measure the input shaft end play with the
transaxle in the vertical position. Input shaft end
play must be within 0.005 to 0.025 inch. For
example, if end play reading is 0.055 inch, select
No. 4 Thrust Plate which is 0.071 to 0.074 thick.
This should provide an input shaft end play read-
ing of 0.020 inch which is within specifications.
(f) Refer to the No. 4 thrust plate chart to select
the proper No. 4 thrust plate:
Fig. 144 Remove Oil Pump O-Ring
1 - OIL PUMP ASSEMBLY
2 - O-RING
NO. 4 THRUST PLATE CHART
PART NUMBER
4431665AB
3836237AB
4431666AB
3836238AB
4431667AB
3836239AB
4431668AB
3836240AB
4431669AB
3836241AB
4446670AB
4446671AB
THICKNESS
1.60mm (0.063 in.)
1.73mm (0.068 in.)
1.80mm (0.071 in.)
1.96mm (0.077 in.)
2.03mm (0.080 in.)
2.16mm (0.085 in.)
2.24mm (0.088 in.)
2.39mm (0.094 in.)
2.46mm (0.097 in.)
2.62mm (0.103 in.)
2.67mm (0.105 in.)
2.90mm (0.114 in.)
Fig. 145 Measure Input Shaft End Play Using End
Play Set 8266
1 - TOOL 8266–8
2 - TOOL 8266–2
3 - TOOL C-3339
(53) Install input clutch assembly (Fig. 146).
Fig. 146 Install Input Clutch Assembly
1 - INPUT CLUTCH ASSEMBLY
2 - #4 THRUST WASHER
RS