Chrysler Dodge Caravan 2002 Manual page 2000

RS
DOOR GLASS (Continued)
Fig. 6 FRONT DOOR GLASS CLIPS
1 - DOOR GLASS
2 - GLASS LIFT PLATE
3 - CLIP
4 - GUIDE RAIL
5 - REGULATOR LIFT PLATE
INSTALLATION
(1) Install clips that attach door glass to regulator
lift plates (Fig. 6).
(2) Place glass in window opening with front
inserted between run channel and outer door panel
(Fig. 7).
(3) Lower glass downward into door.
(4) Insert ends of glass into glass run weatherstrip
channels at front and rear of door.
(5) Place glass in position on regulator lift plates.
(6) Snap glass mounting studs into clips on regu-
lator lift plates.
(7) Install radio speaker, if equipped.
(8) Install outer belt molding. (Refer to 23 - BODY/
WEATHERSTRIP/SEALS/FRONT
BELT MOLDING - INSTALLATION)
(9) Install inner belt molding.(Refer to 23 - BODY/
WEATHERSTRIP/SEALS/FRONT
BELT MOLDING - INSTALLATION)
(10) Verify door glass operation and fit.
(11) Install watershield. (Refer to 23 - BODY/
DOOR - FRONT/WATERSHIELD - INSTALLATION)
1 - DOOR GLASS
2 - FRONT DOOR
3 - GLASS RUN CHANNEL
FRAME CLOSEOUT MOLDING
REMOVAL – A-PILLAR, HEADER, OR B-PILLAR
out molding from window frame channel (Fig. 8).
INSTALLATION – A-PILLAR, HEADER, OR
DOOR OUTER
B-PILLAR
DOOR INNER
channel starting at the corners and working inward.
Fig. 7 FRONT DOOR GLASS
(1) Roll door glass down.
(2) Using a hook tool, pull front door frame close-
(3) Remove closeout molding from vehicle.
(1) Position closeout molding in window frame.
(2) Insert closeout molding into window frame
(3) Verify door glass operation.
DOOR - FRONT 23 - 17