21 - 386
T850 MANUAL TRANSAXLE
INPUT SHAFT (Continued)
(11) Stake 5th Gear nut as follows:
(a) Install staking tool 8479 to 5th gear nut.
(b) Tighten upper thumb screw by hand (Fig.
224).
(c) Tighten two (2) side thumb screws by hand.
(d) Tighten both staking screws until they bot-
tom on tool body (Fig. 225).
(e) Loosen staking screws and thumb screws.
Remove tool and visually inspect stake (Fig. 226).
Fig. 224 Staking Tool Set-Up
1 - STAKING TOOL 8479
2 - THUMB SCREWS (3)
NOTE: The input shaft sealed roller bearing and
snap ring do not get installed until transaxle assem-
bly to facilitate installation of the reverse idler gear
mechanism.
Fig. 225 Tighten Stake Screws
1 - STAKING TOOL 8479
Fig. 226 5th Gear Nut Stake
1 - STAKE
2 - 5TH GEAR NUT
RS