Table of Contents
Advertisement
RG
ACCESSORY DRIVE
SPECIFICATIONS - ACCESSORY BELT
TENSION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
. . . . . . . . . . . . . . . . . . . . . . . . . . 9
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
INSTALLATION
. . . . . . . . . . . . . . . . . . . . . . . . . 10
ACCESSORY DRIVE
SPECIFICATIONS - ACCESSORY BELT TENSION
ACCESSORY DRIVE
BELT
2.5L DIESEL ENGINE
A/C Compressor/
Generator
Power Steering Belt
BELT TENSIONER
REMOVAL
WARNING:: BECAUSE OF HIGH SPRING TENSION,
DO NOT ATTEMPT TO DISASSEMBLE THE AUTO-
MATIC BELT TENSIONER. THE TENSIONER IS SER-
VICED AS AN ASSEMBLY.
(1) Remove the power steering belt (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
REMOVAL).
(2) Remove the accessory drive belt (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
INSTALLATION).
(3) Remove the belt tensioner retaining bolt and
remove tensioner (Fig. 1).
INSTALLATION
(1) Install belt tensioner and retaining bolt (Fig.
1). Torque bolt to 47 N·m (35ft. lbs.).
ACCESSORY DRIVE
TABLE OF CONTENTS
page
. 10
GAUGE
Dynamic Tensioner
300 N (67 lbs.)
. . . . . . . . . . . . . . . . . . . . . . . . . 11
REMOVAL
. . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Fig. 1 BELT TENSIONER AND IDLER PULLEY
1 - BELT TENSIONER RETAINING BOLT
2 - BELT TENSIONER
3 - IDLER PULLEY
4 - VIBRATION DAMPER/CRANKSHAFT PULLEY
5 - VIBRATION DAMPER/CRANKSHAFT PULLEY RETAINING
BOLTS
(2) Install the accessory drive belt (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
INSTALLATION).
(3) Install the power steering belt (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
INSTALLATION).
ACCESSORY DRIVE
. . . . . 10
. . . . . . 11
7a - 9
page
. . 10
. . . . 10
. . 13
. . . 13
Advertisement
Chapters
Table of Contents
