Chrysler Dodge Caravan 2002 Manual page 2028

RS
BODY SIDE MOLDINGS (Continued)
1 - GUIDE PINS
2 - FRONT DOOR MOLDING
INSTALLATION
Refer to (Fig. 1), (Fig. 2), (Fig. 3), (Fig. 4) or (Fig.
5)for proper location of fasteners to hold the molding
to the wheelhouse lip and rocker panels.
(1) If molding is to be reused;
(a) Remove tape residue from molding.
(b) Clean back of molding with Mopar
Kleen, or equivalent.
(c) Wipe molding dry with lint free cloth.
(d) Apply a single coat of Mopar TPO Molding
Prep to tape side of molding and allow to dry thor-
oughly.
(e) Apply new body side molding (two sided
adhesive) tape to back of molding.
Fig. 1 BODY SIDE MOLDINGS - BASE TYPICAL
Super
3 - SLIDING DOOR MOLDING
4 - QUARTER PANEL MOLDING
(2) Clean body surface with Mopar Super Kleen,
or equivalent. Wipe surface dry with lint free cloth.
(3) Remove protective cover from tape on back of
molding.
(4) Apply molding to body from front to rear,
inserting locator pins into hole in body panel.
(5) Using a roller tool, roll molding onto body
panel with enough force to assure adhesion. Do not
apply excessive force, or damage to body panels may
result.
(6) Install pop rivets to hold molding edge to
wheelhouse lip, if necessary.
EXTERIOR 23 - 45