RS
T850 MANUAL TRANSAXLE (Continued)
(7) Install starter motor into position (Fig. 84).
Install and torque bolts to 54 N·m (40 ft. lbs.).
Fig. 84 Starter Motor Removal/Installation
1 - STARTER MOTOR
2 - BOLT (3)
(8) Install engine front mount bracket. Install and
torque bracket-to-transaxle bolts to 102 N·m (75 ft.
lbs.). Install and torque bracket-to-engine bolts to 68
N·m (50 ft. lbs.). Torque through-bolt and nut to 68
N·m (50 ft. lbs.).
(9) Install clutch slave cylinder into position, not-
ing orientation of different sized lugs (Fig. 85). While
Fig. 85 Slave Cylinder Removal/Installation
1 - MOUNTING HOLE
2 - SLAVE CYLINDER
3 - ACCESS HOLE
4 - NYLON ANTI-ROTATION TAB
5 - QUICK CONNECT
T850 MANUAL TRANSAXLE
depressing inward, rotate slave cylinder clockwise
60° into position until nylon locating tab rests within
transaxle case cutout, and hydraulic tube is vertical.
Connect "quick-connect" connection until an audible
"click" is heard. Verify connection by pulling outward
on connection.
(10) Install underbody splash panel.
(11) Install halfshafts and front wheel/tire assem-
blies. (Refer to 3 - DIFFERENTIAL & DRIVELINE/
HALF SHAFT - INSTALLATION)
(12) Lower vehicle.
(13) Install right mount bracket to transaxle (Fig.
86).
Fig. 86 Transaxle Right Mount and Bracket
1 - MOUNT BRACKET
2 - BOLT (3)
3 - MOUNT
4 - BOLT (1)
21 - 341