Table of Contents
Advertisement
JetMove 3000 Supply Unit
A.1.1 Technical data - Brake chopper BG 1
Device
Mains voltage
Power electronics - brake chopper
Operating point - brake chopper
Transient protection
Continuous braking power [kW]
Peak braking power for max. 0.5 s *)
Maximum ohmic resistance of an
externally connected brake resistor
Minimum ohmic resistance of an
externally connected brake resistor
Supply unit with integrated brake resistor: Configuration JM-3P10-R1
Continuous braking power
Peak braking power for max. 0.5 s *)
Ohmic resistance of the
integrated brake resistor
*) After this time the device is switched off after I²t
Table A.2 Technical data - Brake chopper BG 1
NOTICE
Jetter AG
INFO
In the overall axis group, a DC link capacitance of ≥ 100 μF/kW (for 3 x 400
V) or ≥ 170 μF/kW (for 3 x 230 V), referred to the highest rated power that oc-
curs, must be provided. This capacitance is calculated by adding the capaci-
tances of the individual devices. The root mean square of the active power for
a load cycle is defined as the active power.
230 V AC
DAMAGE TO THE DEVICE DUE TO CONNECTION OF AN
ADDITIONAL EXTERNAL BRAKE RESISTOR
IGNORING THESE INSTRUCTIONS COULD RESULT IN DAMAGE
TO MATERIAL
y Do not connect any additional external brake resistors to devices
with integrated brake resistor.
JM-3P10/JM-3P10-C1
400 V AC
411 V
652 V
446 V
687 V
3 kW
3 kW
13 kW
13 kW
90 Ω
90 Ω
33 Ω
33 Ω
75 W
3 kW
56 Ω
480 V AC
765 V
800 V
3 kW
16 kW
90 Ω
38 Ω
63
Advertisement
Table of Contents
