Table of Contents
Advertisement
Safety
1.3
Intended Use
The JM-3000 supply unit is a component designed for installation in industrial and commercial plants and
machines.
Installation is only permitted in stationary equipment.
The JM-3000 multi-axis motion system consists of at least one supply unit and at least one servo ampli-
fier. In motor operating mode, the supply unit draws power from the supply network and provides it to the
connected servo amplifiers via the DC link.
When the supply unit is installed in a machine, commissioning (i.e. commencement of the intended use)
is prohibited until it has been determined that the machine complies with Machinery Directive 2006/42/
EC. Commissioning, i.e. the commencement of the intended use is only permitted if the EMC Directive
(2014/30/EC) is complied with.
The JM-3000 supply unit complies with the Low Voltage Directive
2014/35/EC. It has been tested and certified according to appli-
cable standards (see Declaration of Conformity).
1.4
Usage other than intended
The supply unit must not be used outside a control cabinet.
Servo amplifiers from other manufacturers must not be operated on the supply unit.
The use of the supply unit in special areas of application (e.g. in potentially explosive areas) is not permit-
ted.
Use in non-stationary equipment is considered an exceptional environmental condition and is only permit-
ted by separate agreement.
Our devices are:
Not intended for installation in vehicles. Deployment of the device in mobile equipment is classed as
‚
non-standard ambient conditions and is permissible only by special agreement.
Not intended for installation in environments with harmful oils, acids, gases, vapours, dusts, radiation
‚
etc.
Not approved for usage in special applications (e.g. in potentially explosive atmospheres or areas in
‚
which there is a risk of fire).
Not approved for usage outside a switch cabinet.
‚
Not approved for the generation of high-frequency onboard networks for which the devices are not
‚
designed.
NOTE:
The use of devices in warehouse storage and retrieval systems that are operated inside and outside the rack aisle on
rails is allowed provided the vibration does not exceed the maximum standard values 3M1 as per DIN EN 60721-3-3.
Jetter AG
JetMove 3000 Supply Unit
15
Advertisement
Table of Contents
