Control Connections (Front Panel) - Jetter JetMove 3000 User Manual

JetMove 3000 Supply Unit

3.12 Control connections (front panel)

Step Action
1 1 . .
Establish a connection between terminal X3 of
the supply unit and X3 of the first servo amplifier
(cross communication).
2 . 2
Wire the programmable relay contacts X5 and X6,
as well as the test pulse outputs TP01 and TP02
as required.
3 3 .
Check all connections again!
Fig.
ERR
Voltage
RO01NC TP00
RO01CO TP01
RO01NO GND
X6 / State
RO02CO
RO02NO
X5 / REL Output
Table 3.11 Layout of supply unit (front panel)
52
Comment
For this, use the supplied XCOM cable.
See Appendix
Abbreviation Designation
LED red Error status of supply unit
(ERR) (flashing code)
LED green
Power supply status
(Voltage)
X3 / XC OUT Cross communication
X5 / REL Output Relay contact (RO02)
Relay contact (RO01)
X6 / State Digital outputs (TPO1,
TPO2)
Installation
Details
See chapter 4
See chapter 4
See chapter see Fig.
3.12.1
See chapter see Fig.
3.12.2
See chapter see Fig.
3.12.3
Jetter AG