Safety; Measures To Ensure Your Safety - Jetter JetMove 3000 User Manual

Safety

1 Safety
1.1

Measures to ensure your safety

The following instructions must be read before initial commissioning to avoid personal injury and/or dam-
age to property. Observe the safety instructions at all times.
Read the operating instructions first!
1.
Do not start the implementation until you have understood these
‚
instructions.
Electric motion systems are dangerous by design:
Electrical voltages of 400 V AC or 565 V DC to 480 V AC or 678 V
‚
DC
Dangerous high voltages ≥ 50 V may be present even 3 minutes
‚
after disconnection from mains power (capacitor charge). Therefore
check that no voltages are present!
Follow the instructions of the warning label on the device (see front
‚
panel).
Warning of hot surfaces!
Temperatures of up to 100 °C can occur on the heat sink of the unit. Ad-
jacent devices, especially above the heat sink, may be damaged. Contact
with hot surfaces may cause burns.
Maintain sufficient distance to adjacent modules!
‚
Provide suitable protection against accidental contact with the heat
‚
sink.
Protection against magnetic and/or electromagnetic fields during
installation and operation:
Persons with heart pacemakers, metallic implants or hearing aids, etc.
must not enter the following areas:
Areas where drive systems are installed, repaired or operated.
‚
Areas where motors are installed, repaired or operated. Motors with
‚
permanent magnets are particularly dangerous.
If it is necessary to enter these areas, first consult a doctor for a deci-
‚
sion if this is safe.
Jetter AG
JetMove 3000 Supply Unit
13