Mounting The Unit On The Cooler - Jetter JetMove 3000 User Manual

JetMove 3000 Supply Unit

2.5.2 Mounting the unit on the cooler

For optimum heat transfer from the rear wall of the unit to the corresponding cooler, a heat conducting
film is already glued onto the cooling plate of the unit (see Fig. 2.8). The film is laminated with aluminum
towards the cooler. The device can be mounted or dismounted with the film.
Fig. 2.8 Rear panel with film - JM-3000 Servo amplifier BG1 (ColdPlate)
NOTICE
28
DAMAGE TO THE DEVICE DUE TO INCORRECT INSTALLATION
INCORRECT INSTALLATION COULD RESULT IN THE UNIT OVER-
HEATING DUE TO POOR HEAT TRANSFER
ƒ Make sure that there is no dirt between the cooler and the rear of
the unit during installation.
Mechanical installation
Jetter AG