Table of Contents
Advertisement
JetMove 3000 Supply Unit
2.2
Mounting clearances
NOTICE
*) The bending radius of the mains cable must be taken into account
Fig. 2.2 Mounting clearances JM-3000
The decisive factor for the clearance below the device is the mains cable of the supply unit:
Bending radius of mains cable up to 3 x 10 mm2 (for BG1) - approx. 48 to 98 mm (depending on
ƒ
cable type)
Bending radius of mains cable up to 3 x 16 mm2 (for BG2) - approx. 150 to 200 mm (depending on
ƒ
cable type)
20
DAMAGE TO THE DEVICE DUE TO INCORRECT INSTALLATION
IGNORING THE INSTRUCTION COULD RESULT IN DAMAGE TO
MATERIAL.
ƒ The minimum clearances shown in the following figure apply to both
supply units and servo amplifiers.
ƒ The clearance above is important to avoid heat accumulation.
ƒ The clearances below and in front are important to ensure correct
cable routing.
≥ 130
≥ 200
Mechanical installation
≥ 300
Jetter AG
Advertisement
Table of Contents
